The compression can be determined by gauging (incremental filling). To do this, the piston of the cylinder to be measured must be brought to ignition TDC and then filled with a liquid via the spark-plug hole. This can be done using a syringe whereby, the exact amount, right up to and including the spark-plug thread, is to be noted. The engine is to be placed in a position where the cylinders are vertical, so that no air-bubbles can develop.

The procedure is then repeated with the piston at BDC. Problems can arise with the proper closing of both valves. This could be achieved by removing the OHC or the rocker-arm(s). Indeed, one could also rely on the individual cylinder displacement stated by the manufacturer.

Now one only has to subtract the the volume of the spark-plug hole. Perhaps one could immerse an original spark-plug up to the washer in water, then measure the water-level to determine the volume. The final calculation follows by dividing the two values. (see above). 07/07