Imprint Contact 868 Videos
900.000 Callings



Formulary
Exercises

Wheel change
Save Energy
History


Video Workshop Tester 1
Video Workshop Tester 2
Video Workshop Tester 3
Video Workshop Tester 4
Video Clean engine compartment
Video Multimeter
Video Clamp-on Ammeter
Video Alternator (Test)
Video Scanner 1
Video Scanner 2
Video Micrometer
Video Dial Gauge
Video Caliper Gauge
Video Oblique angle
Video Pulling Tools
Video Gaskets 1
Video Gaskets 2
Video Screws
Video Data for Monitoring
Video Leakage Test
Video On Board Diagnosis
Video ACC-control
Video Test Analyser
Video Compression Check 1
Video Compression Check 2
Video Loss in Pressure Test
Video RPM-Measuring
Video Fiberscope
Video Stethoscope
Video Refractometer
Video Magn field cur. sensor
Video Temperature measuring
Video Layer thickness
Video Microscope
Video Anemometer
Video Engine Test Bench
Video Perf. Measurement 0
Video Perf. Measurement 1
Video Perf. Measurement 2
Video Brake Test Stand 1
Video Brake Test Stand 2
Video Axle Alignment 1
Video Axle Alignment 2
Video Axle Alignment 3
Video Axle Alignment 4
Video Axle Alignment 5
Video Axle Alignment 6
Video Shock Absorber Test 1
Video Shock Absorber Test 2
Video Fault finding
Video Searching f. noises
Video Hoist
Video Separation
Video Wheel Balancing
Video Petrol Injection Signal
Video Trigger
Video Alternator Analysis
Video Voltage Regulation
Video Lambda Sensor
Video Mains voltage 1
Video Mains voltage 2

Video Workshop 1
Video Workshop 2
Video Workshop 3
Video Workshop test 1
Video Workshop test 2


          A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Caliper Gauge







Assignment

In production, gauges are generally everyday instruments, but not only there. They allow only a decision between 'usable', 'scrap' or rectification. In a mass production series, the producing machine itself examines each part after manufacturing, and corrects itself automatically. In smaller series, and in repair-jobs, the person doing the job must do this. What ever the case may be, it is important. If a wrong measurement is discovered too late, the repair costs are distinctly higher. Under no circumstances at all, may a part which lies outside the defined tolerances, leave the workshop/factory.

Function

The caliper has two sides, a good side (right) and a scrap side (left). The latter sometimes is marked in red. The diameter of the shaft may not be larger than the good side. Therefore, this must fit aound the shaft. To ensure however, that the shaft diameter is not too small, it is also determined, that the scrap side, which indicates the minimum, does not fit aound the shaft. If however, it does, the shaft is then to be rejected. 07/09




cartecc.com               Top of page               Index
2001-2015 Copyright programs, texts, animations, pictures: H. Huppertz - E-Mail
Translator: Don Leslie - Email: lesdon@t-online.de

Our E-Book advertising